63 21 183 Removing and installing/replacing left or right rear light (on tailgate)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release expanding rivets (1) and fold down tailgate trim panel (2) slightly.

Fig 1: Identifying Tailgate Trim Panel And Expanding Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace expanding rivets.

Unfasten plug connection (1) and disconnect.

Unfasten screws (2).

Tightening torque 61 21 2AZ .

Fig 2: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rear light (1) in direction of arrow.

Fig 3: Removing Rear Light

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The seal (1) must not be damaged or missing.

Fig 4: Identifying Sealing Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: