63 99 431 Replacing bulb for front interior roof light

WARNING: This page is about a different variant/trim than selected.

Special tools required:

WARNING: Follow notes for HANDLING LIGHT BULBS (INTERIOR LIGHTS) .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Carefully unclip cover (1) with special tool 00 9 323 and remove.

Installation note:

Ensure cover (1) is correctly seated.

Fig 1: Removing Cover Using Special Tool 00 9 323

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock retaining lugs (1) with suitable tool while carefully lifting out with special tool 00 9 325 .

Remove roof switch cluster (2) in direction of arrow.

Do not disconnect plug connections underneath (fault code entries possible).

Installation note:

Retaining lugs (1) must not be damaged.

Make sure roof switch cluster (2) is correctly fitted.

Fig 2: Removing Roof Switch Cluster

Courtesy of BMW OF NORTH AMERICA, INC.

Turn bulbs in direction of arrow and remove.

Installation note:

Fig 3: Removing Bulbs

Courtesy of BMW OF NORTH AMERICA, INC.