63 99 002 Replacing halogen bulb for high beam headlight on left

WARNING: This page is about a different variant/trim than selected.

WARNING: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

Open end cover of engine compartment lid seal mounting (1) in direction of arrow.

Fig 1: Opening End Cover Of Engine Compartment Lid Seal Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Turn protective cap (1) counterclockwise and remove.

IMPORTANT: Risk of damage due to moisture penetration.

Installation note:

Check seal. Replace protective cap (1) if necessary.

Protective cap (1) must lock correctly.

Turn the protective cap (1) clockwise to end stop (A).

Fig 2: Turning Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Turn bulb holder (1) in direction of arrow and remove towards rear from headlight (2).

Fig 3: Removing Bulb Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Detach bulb (1) from bulb holder (2).

Installation note:

Make sure bulb holder (2) is seated correctly.

Fig 4: Identifying Bulb And Bulb Holder

Courtesy of BMW OF NORTH AMERICA, INC.