63 11 840 Replacing left LED fan left (outer)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Turn protective cap (1) counterclockwise and remove.

IMPORTANT: Risk of damage due to moisture penetration.

Installation note:

Check seal. Replace protective cap (1) if necessary.

Protective cap (1) must lock correctly.

Turn the protective cap (1) clockwise to end stop (A).

Fig 1: Turning Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Unfasten screws (2).

Tightening torque 63 11 5AZ .

Remove LED fan (3).

Fig 2: Identifying LED Fan Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.