41..... Filling Bulkhead Cross Member With Foam
WARNING: This page is about a different variant/trim than selected.
For acoustic insulation reasons insulating foam is applied to the finish-painted bodyshell in the bulkhead cross member area.
A 2-component PU cavity foam is used.
Observe SAFETY AND APPLICATION INSTRUCTIONS .
Remove seal plugs of cavities 1 to 3 and fill cavities with foam.
In so doing, insert spray pipe into bores and slowly pull out during the spraying operation.
To perform the operation, it may be necessary to lengthen the spray pipe.
IMPORTANT:
Empty the can within 8 minutes.
Follow manufacturer's safety instructions.
Follow manufacturer's safety instructions.