41 11 095 Replacing Left Engine Support In Front Of Wheel Arch
WARNING: This page is about a different variant/trim than selected.
Follow procedure for REPAIR STAGE 3 .
Read contents of BODY, GENERAL .
Use only APPROVED SPOT-WELDING APPARATUS for repairs.
Place vehicle on straightening bench.
Necessary preliminary work:
The following new body parts are required:
- (1) Engine support, front
Mark severance cut in accordance with Dimension "a" and cut.
Dimension "a"=40 mm before wheel arch edge.
Remove section of engine support.
Installation note:
Mark severance cut on new part in accordance with vehicle and cut.
Adjust new part to fit with alignment bracket or universal mount.
Weld in REINFORCEMENT PLATE at severance cut.