41 62 000 Removing And Installing Tailgate
WARNING: This page is about a different variant/trim than selected.
Read contents of BODY, GENERAL .
Necessary preliminary work:
- Remove PANEL FOR TAILGATE .
- Disconnect all cable plug connections and pull wiring harness out of tailgate.
Carry over the work step shown symmetrically to the other side of the vehicle.
Release screws (1) and (2) and remove tailgate with a second person.
Tightening torque 41 62 1AZ .
Installation note:
Install tailgate at screw locations on hinge.
If necessary, ADJUST TRUNK LID .
If reversing camera optional equipment installed:
Calibrate REVERSING CAMERA .