41 12 548 Stripping Operations - Replacing Rear Cross-Member On Luggage Compartment Floor (Tail Panel Removed)

WARNING: This page is about a different variant/trim than selected.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Remove exhaust system (job number: 18 00 020)
Remove heat shields

Undo the positive battery cable (1).

Undo nut (2) and put cable channel (3) including wiring harness to one side.

Fig 1: Identifying Positive Battery Cable, Cable Channel, And Nut

Courtesy of BMW OF NORTH AMERICA, INC.