LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 56 (Collision - Body Panel Repair (F13)) >> Front Lid >> 41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

WARNING: This page is about a different variant/trim than selected.
WARNING: Danger of injury.
The BATTERY EARTH LEAD must be clamped off on vehicles with AFGS active pedestrian protection.
Adhere to the following SAFETY INFORMATION so as to avoid a danger of injury by the actuator.
IMPORTANT: Support engine compartment lid in fully opened position with suitable apparatus.
Removal of the engine compartment lid must be carried out with the assistance of a second person.

Follow instructions on ACTIVE PEDESTRIAN PROTECTION  system.

Necessary preliminary tasks: 

Disconnect NEGATIVE BATTERY CABLE .

Unscrew nuts (1).

Remove engine compartment lid.

Installation note: 

Install engine compartment lid at screw locations to on hinge.

Tightening torque 41 61 1AZ .

If necessary, adjust ENGINE COMPARTMENT LID .

Fig 1: Identifying Hinge Nuts
G04791372Courtesy of BMW OF NORTH AMERICA, INC.