24 00 Transmission in general
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION IN GENERAL
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Transmission to engine | ||||
| Torx bolts | GA6HP19Z/GA6HP26Z/GA8HP45Z/GA8HP50Z/GA8HP70Z/GA8HP75Z/GA8HP90Z | M6 | 9 Nm | ||
| Torx bolts | GA6HP19Z/GA6HP26Z/GA8HP45Z/GA8HP50Z/GA8HP70Z/GA8HP75Z/GA8HP90Z | M10x8.8 | 38 Nm | ||
| GA8HP45Z/GA8HP50Z/GA8P75H | M10x10.9 | 56 Nm | |||
| Steel Torx screws | GA6HP19Z/GA6HP26Z/GA8HP45Z/GA8HP50Z/GA8HP70Z/GA8HP75Z/GA8HP90Z/GA8P70H | M8 | 19 Nm | ||
| GA8HP70Z (N63) | M8 | 21 Nm | |||
| Steel Torx screws | GA6HP19Z/GA6HP26Z/GA8HP45Z/GA8HP50Z/GA8HP70Z/GA8HP75Z/GA8HP90Z/GA8P70H | M12 | 66 Nm | ||
| 2AZ | Transmission to engine N52/N53/N54/N55 Aluminum screws/bolts are not magnetic |
GA6HP19Z/GA6HP26Z/GA8HP45Z | Replace screws Jointing torque and angle of rotation must be observed without fail | ||
| GA6HP19Z | M10x30 | Jointing torque | 20 Nm | ||
| Angle of rotation | 90-110 ° | ||||
| GA6HP19Z | M10x85 | Jointing torque | 20 Nm | ||
| Angle of rotation | 180-200 ° | ||||
| GA6HP19Z/GA8HP45Z | M12 | Jointing torque | 25 Nm | ||
| Angle of rotation | 130 ° | ||||
| 3AZ | Cover plate for transmission | GA6HP19Z/GA8HP45Z/GA8HP50Z | M6 | 9 Nm | |
| 4AZ | Heat shield on gearbox | GA8HP50Z | M6 | 19 Nm | |