24 11 Transmission housing, transmission oil sump
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION HOUSING, TRANSMISSION OIL SUMP
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Transmission oil sump | GA6HP19Z/GA6HP26Z/GA6HP32Z | M6 | 10 Nm | |
| 2AZ | Oil drain plug | GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8P75H/GA8HP75Z | M16x1.5 M24x1 M18x1 |
Plastic oil sump | 8 Nm |
| S63 GA8HP75Z | 12 Nm | ||||
| 3AZ | Oil filler plug | GA6HP26Z/GA6HP32Z | M30x1.5 | 80 Nm | |
| GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8HP90Z/GA8P75H | M18x1.5 | 35 Nm | |||
| 4AZ | Transmission oil sump | GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8HP90Z/GA8P75H | M6 | Replace aluminum screws; jointing torque and angle of rotation must be observed without fail. | |
| 1. Jointing torque | 4 Nm | ||||
| 2. Angle of rotation | 45 ° | ||||
| Steel screws | 10 Nm | ||||
| 5AZ | Oil drain plug | GA8HP90Z | M10 | 12 Nm | |
| 6AZ | Heat shield on gearbox | GA8HP45Z/GA8P70Z/GA8P75H | M8 | 19 Nm | |
| GA8HP45Z | M6 | 8 Nm | |||
| 7AZ | Ground strap to body and transmission | GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8P75H | M8 | 19 Nm | |