24 40 Torque converter
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TORQUE CONVERTER
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Torque converter to flywheel | GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50Z/GA8HP70Z GA8HP75Z |
M10 10.9 | Replace converter screws. (Remove adhesive residue from thread, if applicable) |
56 Nm |
| GA6HP26Z/GA8HP75Z/GA8HP90Z/(AWD) | M10 10.9 | Replace converter screws. (Remove adhesive residue from thread, if applicable) |
60 Nm | ||
| F30/F31/F32/F33/F35 N20 GA8HP45Z | M10 10.9 | Replace converter screws. (Remove adhesive residue from thread, if applicable) |
60 Nm | ||
| 2AZ | Electrical machine to flywheel | GA8P70H | M10 | Replace hexagon nuts. (Remove adhesive residue from thread, if applicable) |
56 Nm |