23 21 Transmission shafts
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION SHAFTS
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Output flange | S5D 200G/S5D 250G/S5D260Z/S5D 310Z/S6S 420G | Collar nut installed with screw locking | ||
| Pretension | 190 Nm | ||||
| Release | |||||
| Tighten down | 120 Nm | ||||
| S5D 280Z/S5D 320Z | Collar nut installed with screw locking | ||||
| Pretension | 170 Nm | ||||
| Release | |||||
| Tighten down | 130 Nm | ||||
| S5D 390Z | Collar nut installed with screw locking | ||||
| Pretension | 200 Nm | ||||
| Release | |||||
| Tighten down | 145 Nm | ||||
| GS6-17BG/GS6-37BZ | Collar nut installed with screw locking | ||||
| Pretension | 170 Nm | ||||
| Release | |||||
| Tighten down | 120 Nm | ||||
| GS6-45BZ | Collar nut installed with screw locking | ||||
| Pretension | 200 Nm | ||||
| Release | |||||
| Tighten down | 150 Nm | ||||
| GS6-53DZ/BZ | Collar nut installed with screw locking | ||||
| Pretension | 200 Nm | ||||
| Release | |||||
| Tighten down | 140 Nm | ||||
| GS7S47BG | Collar nut installed with screw locking | 200 Nm | |||
| 2AZ | Gear to countershaft | 265/Sport | M10 | 60 Nm | |
| 3AZ | Adapter shaft to the output | GS6X45BZ | 68 Nm | ||