23 00 Transmission in general (GS6-53BZ)
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION IN GENERAL
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| TRANSMISSION DESIGNATIONS, SEE 23... | |||||
| 1AZ | Transmission to engine (Aluminum screws/bolts are not magnetic). | Replace aluminum screws/bolts. Jointing torque and angle of rotation must be observed without fail |
|||
| N53/N55 | M12 | Jointing torque | 25 Nm | ||
| Angle of rotation | 130 ° +20 ° | ||||
| M10X85 | Jointing torque | 20 Nm | |||
| Angle of rotation | 180°- 200 ° | ||||
| N53/N55 | M8 | Steel screw | 19 Nm | ||
| N53/N55 | M12 | Steel screw | 66 Nm | ||
| K transmission | M8 | Steel screw | 19 Nm | ||
| K transmission | M12 | Steel screw | 66 Nm | ||
| I-transmissionN13 | M10 | Steel screw | 38 Nm | ||
| I-transmissionN20 | M10 | Steel screw | 56 Nm | ||
| 2AZ | Oil drain plug/oil filler plug | H/G-transmission | M18x1.5 hexagon socket | 35 Nm | |
| H/I transmission | M12x1.5 | 25 Nm | |||
| I-transmission | M18x1.5 | Steel screw without seal | 45 Nm | ||
| K transmission | Hexagon socket | 40 Nm | |||