23 11 Housing with lid
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - HOUSING WITH LID
| TRANSMISSION DESIGNATION | Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|---|
| 1AZ | Transmission housing, rear section/front section | B/C/D/E/F/G/H/I/7-speed SMG | 22 Nm | ||
| 2AZ | Cover with guide tube/transmission case | B/C/D/E/F/G/H/I/C/7-speed SMG | M8 x 22 | 18 Nm | |
| B/C/D/E/F/G/H/I/C/7-speed SMG | M8 x 30 | 25 Nm | |||
| B/C/D/E/F/G/H/I/C/7-speed SMG | M6 | 10 Nm | |||
| 3AZ | Bearing cap/sealing flange | B/C/D/E/F/G/H/I/7-speed SMG | 10.5 Nm | ||
| 4AZ | Reverse gear wheel axle to intermediate housing | B/C/D/E/F/G/H/I/7-speed SMG | 49 Nm | ||
| 5AZ | Retaining plate for reverse gear wheel axle to intermediate case | B/C/D/E/F/G/H/I/7-speed SMG | 25 Nm | ||
| 6AZ | Transmission closing plate | B/C/D/E/F/G/H/I/7-speed SMG | M6 | 8 Nm | |
| 7AZ | Transmission oil strainer in transmission | G-transmission | M18 | 25 Nm | |