33 55 021 Replacing both rubber mounts for stabilizer mounting

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

IMPORTANT: Circo Light must not be used between stabilizer and rubber mount!

Remove retaining bracket (1) and rubber mount (2) from stabilizer.

Installation:

Coat rubber mount with Circo Light to install retaining bracket.

Fig 1: Identifying Stabilizer Rubber Mount And Retaining Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep stabilizer clean and free of oil and grease.

Mount rubber mount (1) by way of slot (2) as pictured on stabilizer.

Fig 2: Identifying Stabilizer Rubber Mount And Slot

Courtesy of BMW OF NORTH AMERICA, INC.