LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Rear Axle - Repair - F13) >> Rear Sub-Frame >> 33 31 000 Removing and installing complete rear axle support

33 31 000 Removing and installing complete rear axle support

WARNING: This page is about a different variant/trim than selected.
WARNING: Danger of injury!
Failure to comply with the following instructions may result in the vehicle slipping off the lifting platform and critically injuring other persons.
Load the luggage compartment with a minimum of 100 kg before lowering/removing the rear axle support.
When supporting components, make sure that:
  • the vehicle can no longer be raised or lowered
  • the vehicle does not lift off the locating plates on the vehicle hoist.
IMPORTANT: Observe SAFETY INFORMATION for raising the vehicle
In order to avoid damage to vehicle hoist, perform weight compensation on vehicle.
NOTE: The subsequent procedure is described in the document "LOWERING/RAISING REAR AXLE SUPPORT ".