66 53 522 Replacing reversing camera

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Unclip the fastener (1) from the plug connection (2).

Fig 1: Identifying Plug Connection And Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock latch mechanism (1) and detach connector housing (2) from plug connection.

Fig 2: Detaching Connector Housing From Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rubber seal (1).

Release screws.

Fig 3: Locating Rubber Seal And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out cable duct (1).

Remove cover (2).

Feed cable (3) out of cover (2).

Fig 4: Identifying Cable, Cable Duct, And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove reversing camera (1) from the housing in direction of arrow.

Installation note:

Ensure correct latching of shaft (1) in housing (3).

Fig 5: Removing Reversing Camera From Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Installation note:

Ensure correct cable routing.

Fig 6: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws.

Remove the connector housing (3) from the reversing camera (2).

Installation note:

Grease the shaft (1) sufficiently prior to installation.

Fig 7: Identifying Reversing Camera, Connector Housing, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.