66 33 008 Removing and installing/replacing park assist control unit

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: Only with 24V steering:

Unscrew nuts (1).

Take off holder (2).

Move the auxiliary battery (3) out of the working area.

Fig 1: Identifying Auxiliary Battery, Holder And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Release plastic nuts (1).

Remove control unit holder (2) from tail panel trim.

Remove park assist control unit (3) from holder (2).

Unlock plug connection (4) and disconnect.

Remove the Parking assistant control unit (3).

Fig 2: Identifying Park Assist Control Unit, Holder, Plug Connection, And Plastic Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: