66 20 515 Removing and installing/replacing an ultrasonic sensor at front left (S63)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Unfasten plug connection (1) and disconnect.

Unclip ultrasonic sensor (2) from retaining tabs.

Installation note:

Retaining tabs must not be damaged.

Make sure ultrasonic transducer (2) is securely seated.

Fig 1: Identifying Ultrasonic Sensor And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).

Fig 2: Identifying Rubber Ring Seated On Ultrasonic Transducer

Courtesy of BMW OF NORTH AMERICA, INC.