66 54 005 Removing and installing/replacing control unit for Night Vision System

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary work:

Unlock plug connections and disconnect.

Release bolt (1) and remove control unit (2) in direction of arrow.

Fig 1: Removing Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Guides (1) on control units (2) must be correctly seated in the applicable bracket.

Fig 2: Identifying Guides On Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

NOTE: New component contains a CD with deblocking code.

CD is requested during encoding/programming by the SSS.