66 54 001 Axially adjusting night vision camera

WARNING: This page is about a different variant/trim than selected.

NOTE: Mechanical setting - as described in the following - is only possible axially .
Vertical alignment can only be carried out with the BMW diagnosis system:

Service functions
-> Driver assistance systems

-> Night vision electronics

-> Calibration night vision electronics camera

NOTE: Installation location: Adjusting screw, Night Vision Camera F07, F10, 11, 18, F12, 13:

Fold up engine compartment lid seal (1) as shown.

NOTE: (2) = Installation location, adjusting screw, night vision camera

Fig 1: Identifying Installation Location

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Front of vehicle must be parallel at distance (A) to headlight aiming device (1).

(A) = 2 m

Align a suitable straight object (2), e.g. a spirit level, horizontally on headlight aiming device.

Slowly carry out axial adjustment of night vision camera at adjusting screw (3).

Fig 2: Positioning Front Of Vehicle And Headlight Aiming Device

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Image shows the CID picture in the vehicle.

If necessary, align the image of the night vision camera with aid of a second person.

Yellow help line (1) is displayed using diagnosis job.

Upper edge (2) must be aligned parallel to yellow help line (1) in the CID using adjusting screw.

Fig 3: Aligning Upper Edge To Yellow Help Line

Courtesy of BMW OF NORTH AMERICA, INC.