66 31 006 Removing and installing (replacing) ACC sensor

Necessary preliminary work: 

• Remove FRONT BUMPER PANEL

Undo screws in marked area on the rear side of the ACC sensor (1).

Tightening torque 66 31 1AZ .

Remove ACC sensor from holder (1).

Fig 1: Locating ACC Sensor Holder Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Remove ACC sensor (2).

Fig 2: Identifying ACC Sensor And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

• If applicable, ADJUST THE ACC SENSOR 

Replacement: 

• Carry out VEHICLE PROGRAMMING AND ENCODING
• ADJUSTING ACC SENSOR