23 00 037 Installing exchange transmission (GS6-53BZ) N63, S63
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check gearbox oil level
. See 00 11 229 CHANGING/TOPPING UP/CHECKING GEAR OIL IN MANUAL TRANSMISSION
.
Use only the approved TRANSMISSION OIL .
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
Necessary preliminary tasks:
- Drain transmission oil at oil drain plug.
Tightening torque 23 00 2AZ .
- Remove transmission. See 23 00 018 REMOVING AND INSTALLING TRANSMISSION (GS6-53BZ) (N63) or 23 00 018 REMOVING AND INSTALLING TRANSMISSION (GS6-53BZ) (S63 USA)
Remove transmission support block from transmission.
Installation note:
Tightening torque 22 32 1AZ .
Slide back retaining ring (1) and drive out cylinder pin (2).
Transfer gearshift rod joint.
NOTE:
Check damping disc (6) for damage and replace if necessary.
Convert following components from previous transmission to new transmission.
- RELEASE BEARING AND RELEASE LEVER .
- Ball pin and wire spring clip
- Stud bolts for clutch slave cylinder
- PULSE GENERATOR, CRANKSHAFT/TRANSMISSION
- Transmission oil pump
- REVERSING LIGHT SWITCH
- Modify zero-gear sensor.
Tightening torque 23 14 2AZ .
- Adjust zero-gear sensor
Reassemble the vehicle.
Check oil level.
Installation note:
Observe GREASING SPECIFICATION .