23 11 614 Replacing guide tube for clutch operator (GS6-53BZ) N63/S63
WARNING: This page is about a different variant/trim than selected.
NOTE:
(gearbox removed)
Necessary preliminary tasks:
- Remove CLUTCH RELEASE BEARING AND RELEASE LEVER from guide tube
Release screws.
Remove guide tube (1).
IMPORTANT:
Guide tube is coated with Teflon and must not
be greased.
Installation note:
Clean thread.
Install screws with Loctite 243.
Tightening torque 23 11 2AZ .
NOTE:
Remove sticker (1) and adhesive with a suitable solvent.