23 14 561 Removing/replacing zero gear sensor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: After installing the zero-gear sensor, it is necessary to teach in the position of the zero-gear sensor again.
Calibration is carried out using the BMW Diagnosis System "Service Function" (Learn/record zero-gear sensor).

Necessary preliminary tasks:

REMOVE TRANSMISSION .

Disconnect plug connection (1) on zero gear sensor.

Unfasten screws (2).

Tightening torque 23 14 2AZ .

Remove zero gear sensor.

Installation note:

Replace screws (2).

Fig 1: Identifying Zero Gear Sensor Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.