119510 - Device AM

WARNING: This page is about a different variant/trim than selected.

NOTE: For mounting the radial shaft seal of the crankshaft, front.

Consisting of:

0495472 Basic body
0495473 Screw
NOTE: (screws (2 x))
0495474 Holding sleeve
NOTE: (Sliding sleeve)
0495475 Holding sleeve
NOTE: (Pressure sleeve) Can no longer be ordered separately. Only available as part of set 11 5 330 = 83 30 0 495 127.
0495476 Nut
NOTE: (Nut with bearing) Can no longer be ordered separately. Only available as part of set 31 2 120 = 83 30 0 491 909.