37 14 566 Removing and installing/replacing control unit for Vertical Dynamics Control (EDC)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Remove ignition key
- Disconnect NEGATIVE BATTERY CABLE
- Remove SIDE TRIM PANEL from footwell on right A-pillar
Fold carpet in footwell at front right to one side.
Unscrew nuts (1).
Tightening torque 37 14 6AZ .
Unlock plug connections (1) in direction of arrow and disconnect.
Remove control unit.
After installation:
- Replacement only: Carry out PROGRAMMING/ENCODING