37 14 515 Replacing front left or right ride-height sensor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Unfasten plug connection (1) and disconnect.

Release nut (2) and disconnect jointed rod.

Tightening torque 37 14 4AZ .

Release screw (3) and remove ride-height sensor (4).

Tightening torque 37 14 2AZ .

Fig 1: Identifying Ride-Height Sensor And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1). Remove bracket (2) from ride-height sensor.

Tightening torque 37 14 3AZ .

Fig 2: Identifying Ride-Height Sensor Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: