51 24 146 Removing and installing/replacing button for rear lid actuation

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Version with reversing camera:

Release and disconnect plug connection (1) at microswitch.

Slacken screws (2) until circlip (3) can be twisted.

Tightening torque 51 24 16AZ .

Turn circlip (3) and remove.

Fig 1: Identifying Circlip, Screws, And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Remove button (1) from tailgate (2) in direction of arrow.

Fig 2: Removing Button From Tailgate

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Perform function check with tailgate open.

Replacement:

Install BMW BADGE .