51 13 280 Removing and installing/replacing trim strip on roof frame at left or right: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Starting from the rear, use special tool 00 9 321 to remove trim strip (1) from clips (2).
Installation note:
Replace faulty clips (1 to 3).
IMPORTANT:
Different clips (1 to 3) can be installed.
Version without tilt sunroof:
Clips (1 to 3) are white.
Version with tilt sunroof:
Version without tilt sunroof:
Clips (1 to 3) are white.
Version with tilt sunroof:
- Clips, grey
- Red clip
- Clips, white
In rear area two white clips (3)
Emergency strategy if T-bolt is broken:
Refer to REPAIRING CLIPS FOR ROOF STRIP .
Installation note:
Following parts of trim strip must not be damaged or missing:
- Front end cap
- Rear end cap
- Gasket
Installation note:
Trim strip (1) must be flush with roof outer skin at front and rear.