51 16... Removing and installing/replacing cup holder decorative trim

WARNING: This page is about a different variant/trim than selected.

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary tasks:

Remove CENTER CONSOLE COVER

Close the cover cap (3) and protect from scratching (tape off). Then open again.

Set center console cover (2) upside down onto a soft support.

Mounting holes (1) point up.

Fig 1: Identifying Center Console Cover, Cover Cap, And Mounting Holes

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The work step is shown here removed in semi-transparent condition for purposes of clarity.

Slightly pull the decorative trim (2) in direction of arrow. Thereby unlock the attachment tabs (3) with a screwdriver (1) through mounting holes until the decorative trim (2) can be removed.

Fig 2: Removing Decorative Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Mounting hooks, clip tabs and pins (see arrow) on protective cap (1) and decorative trim (2) must not be damaged.

Replacement

Protect new decorative trim against scratches (tape off).

Fig 3: Locating Mounting Hooks, Clip Tabs, And Pins On Protective Cap And Decorative Trim

Courtesy of BMW OF NORTH AMERICA, INC.