51 16 365 Removing and installing/replacing glove box cover

WARNING: This page is about a different variant/trim than selected.

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary tasks:

Spread U clamp (2) of damper (4) until swivel arm (3) slips out.

NOTE: After turning by 90°, damper (4) of glove box housing (1) can be removed.

Fig 1: Removing Damper Of Glove Box Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (3).

Tightening torque 51 16 15AZ .

If necessary, open glove box cover (1), disengage from clips (2) and remove towards front.

Fig 2: Identifying Glove Box Cover, Clips, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.