51 45 075 Removing and installing/replacing support for dashboard

Necessary preliminary work: 

• Remove INSTRUMENT PANEL TRIM 
• Unclip wiring harness
• Only if equipped with Head-Up Display optional equipment: 
  • Remove HEAD-UP DISPLAY

Release nuts (1) on A-pillar.

Tightening torque 51 45 2AZ .

Release screws (2) on tunnel.

Fig 1: Identifying A-Pillar Nuts And Tunnel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 51 45 3AZ .

Release screws (1) on steering column support (2).

Tightening torque 51 45 1AZ .

Release screws (3) on steering column (4).

Tightening torque 32 31 1AZ .

Fig 2: Identifying Screws On Steering Column And Support

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on earth connection.

Release screw (2) on dashboard trim holder (3).

Fig 3: Identifying Screws On Earth Connection And Dashboard Trim Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on dashboard trim holder (2).

Remove dashboard support and if necessary feed out through front passenger door.

Fig 4: Identifying Screws On Dashboard Trim Holder

Courtesy of BMW OF NORTH AMERICA, INC.