51 47 312 Replacing footrest for front passenger compartment

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work:

NOTE: Footrest (1) is bonded with carpet along line (2).

Adhesive bead must remain on carpet (risk of damage).

Preheat footrest (1) with hot air blower and therefore loosen adhesive bead from footrest (1).

If necessary, tension footrest (1) with panel wedge and apply heat to pull off inwards.

Fig 1: Identifying Footrest Bonding Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If required, preheat footrest (1) with hot air blower and apply adhesive bead along line (2) with a hot-glue gun.

Fit footrest (1) to carpet and bond.

Fig 2: Identifying Adhesive Application Area On Footrest

Courtesy of BMW OF NORTH AMERICA, INC.