32 00 Steering
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - STEERING
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Steering box to front axle carrier | F01/F02/F04/F06/F07/F10/F11/F12/F13/F18 | M12 | Renew screws | |
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 90 ° | ||||
| F01/F02/F07/F10/F11/F12/F13, 4WD | M14 | Replace screws and nuts | |||
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 105 ° | ||||
| F03 | M14 | 165 Nm | |||
| F25/F26 | M12 | 100 Nm | |||
| F15/F16/F85/F86 | M10 | Renew screws | |||
| 1. Jointing torque | 24 Nm | ||||
| 2. Release all bolts again by | 90 ° | ||||
| 3. Jointing torque | 56 Nm | ||||
| 4. Angle of rotation | 90 ° | ||||
| 2AZ | EH converter to steering box | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F15/F16 | 3 Nm | ||
| 3AZ | Heat shield to steering gear | F15/F16 | 8 Nm | ||