31 35 Anti-roll bar
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - ANTI-ROLL BAR
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Retaining bar for stabiliser to front axle carrier/steering gear | F01/F02/F04/F06/F07/F10/F11/F12/F13/F18 | M12 | Replace screw. | |
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 105 ° | ||||
| F03 | M12 | Replace screw. | |||
| Jointing torque | 100 Nm | ||||
| F03 | M14 | Replace screw. | |||
| Jointing torque | 165 Nm | ||||
| F25/F26 | M10 | 56 Nm | |||
| 2AZ | Stabiliser link to stabiliser/damper | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18 | M12 | Replace nuts. | |
| Jointing torque | 45 Nm | ||||
| Angle of rotation | 45° | ||||
| 3AZ | Anti-roll bar link to anti-roll bar | F25/F26 | M12 | Replace nut. | 100 Nm |
| 4AZ | Anti-roll bar link to damper | F25/F26 | M12 | Replace nut. | 108 Nm |