37 13 Hydraulic lines
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - HYDRAULIC LINES
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Pressure line for front axle oscillating motor to valve block | F01/F02/F06/F07/F10/F11/F12/F13/F18 | M8 | 19 Nm | |
| 2AZ | Pressure line for rear axle oscillating motor to valve block | F01/F02/F06/F07/F10/F11/F12/F13/F18 | M8 | 19 Nm | |
| 3AZ | Pressure lines to valve block | F01/F02/F06/F07/F10/F11/F12/F13/F18 | M8 | 19 Nm | |
| 4AZ | Pressure lines to oscillating motor | F01/F02/F06/F07/F10/F11/F12/F13/F18 | M8 | 19 Nm | |
| 5AZ | Screw connection, pressure lines | F01/F02/F06/F07/F10/F11/F12/F13/F18 | 30 Nm | ||
| 6AZ | Line holder to compression strut | F01/F02/F06/F07/F10/F11/F12/F13/F18 | 8 Nm | ||
| 7AZ | Dynamic Drive line clip to rear axle support/front axle support | F01/F02/F06/F07/F10/F11/F12/F13/F18 | M6 | 8 Nm | |
| 8AZ | Flange screw connection, pressure line | F01/F02/F06/F07/F10/F11/F12/F13/F18 | M6 | 8 Nm | |
| 9AZ | Line holder to front axle support | F01/F02/F06/F07/F10/F11/F18 | 6 Nm | ||
| 10AZ | ARS line to hydraulic pump/power steering pump | F01/F02/F06/F07/F10/F11/F12/F13/F18 | 12 Nm | ||
| 11AZ | ARS expansion hose Part 1 to part 4 |
F01/F02/F07 | M6 | 12 Nm | |
| 12AZ | ARS lines rear axle 1+2 to underfloor line 1+2 | F01/F02/F06/F07/F10/F11/F12/F13/F18 | 19 Nm | ||
| 13AZ | Return line, short to valve block | F01/F02/F06/F07/F10/F11/F12/F13 | 19 Nm | ||
| 14AZ | Return line, part 2 to return line, short | F01/F02/F06/F07/F10/F11/F12/F13 | 19 Nm | ||