32 41 426 Replacing expandable hose part 2 for hydraulic steering (S63)
WARNING: This page is about a different variant/trim than selected.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Close off line connections with seal plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable collecting vessel.
Observe country-specific waste disposal regulations
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove front underbody protection
- Remove STIFFENING PLATE
- Remove left steering assembly COVER
Release screw (1) and remove return line (3).
Disconnect pressure line (2).
Installation note:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient spacing to adjoining components.
Tightening torque 32 41 5AZ .
Release screw connection (1) and remove line in downward direction.
Tightening torque 32 41 15AZ .
After installation:
- Fill and bleed HYDRAULIC SYSTEM
- Check line connections for leak tightness