32 41 331 Replacing pressure line for power steering (from steering gear to junction)
WARNING: This page is about a different variant/trim than selected.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Close off line connections with seal plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable collecting vessel.
Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Lower FRONT AXLE SUPPORT (all-wheel drive vehicles)
Release screw (1) and remove pressure line (2) from steering gear.
Tightening torque 32 41 5AZ .
Remove return hose (1) from holder (2).
Release screw (1).
Tightening torque 32 41 15AZ .
Release nut (2) on holder.
Tightening torque 32 41 7AZ .
Disconnect pressure line (3).
Installation note:
Replace all sealing rings.
Make sure hydraulic line is laid without tension and with sufficient distance to adjoining components.
After installation:
- Fill and bleed HYDRAULIC SYSTEM
- Check line connections for leaks