32 41 316 Replace intake pipe for hydraulic pump (from oil reservoir to connecting piece)
WARNING: This page is about a different variant/trim than selected.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness.
Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable expansion tank.
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove OIL RESERVOIR from body
- Remove raw-air supply on left. See 13...... REMOVING INTAKE DUCT (N63) .
Unfasten hose clamp (1).
Disconnect intake pipe (2) from oil reservoir.
Installation note:
Marks on fluid reservoir and intake pipe must match up.
Replace hose clamp.
Unfasten hose clamp (1).
Remove intake pipe (2).
Installation note:
Replace hose clamp.
Make sure intake pipe is laid without tension and with sufficient distance to adjoining components.
After installation:
- Carry out INITIAL DYNAMIC DRIVE OPERATION
- Check line connections for leaks