32 41 250 Removing and installing/replacing fluid reservoir for hydraulic steering (with Dynamic Drive)
WARNING: This page is about a different variant/trim than selected.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with seal plugs.
Seal off hydraulic lines with seal plugs.
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove front left SUSPENSION CROSS-BRACE
Release screws (1) on wheel arch and screw (2) on expansion tank.
Remove washers.
Tightening torque 32 41 1AZ/2AZ .
NOTE:
Raise and/or turn fluid reservoir in order to gain better access to plug connection and hoses.
Release hose clamp (1) from radiator return line.
Tightening torque 32 41 3AZ .
Unfasten hose clamp (2).
Installation note:
Replace hose clamp.
If necessary, disconnect plug connection (3) from oil level sensor
Disconnect intake pipe and radiator return line from fluid reservoir.
Lift out oil reservoir.
Replacement:
If necessary, modify LEVEL SWITCH .
After installation:
- Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT .
- Check pipe connections for leaks
Version with Dynamic Drive:
- If necessary, carry out START-UP DYNAMIC DRIVE OPERATION