32 41 105 Removing and installing/replacing belt pulley for hydraulic pump
WARNING: This page is about a different variant/trim than selected.
NOTE:
Carry out preliminary work as described in the document "Replacing drive belt
". See 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N63)
or 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N55)
.
Slacken screws (1)
Relieve tension on drive belt and remove from belt pulley (2). See 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N63) or 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N55) .
Unscrew bolts (1) and remove belt pulley (2).
Installation note:
Lettering on belt pulley (2) must point forwards.
Replace microencapsulated screws.
Tightening torque 32 41 2AZ/4AZ .