32 41 100 Removing and installing/replacing belt pulley on vane pump for power steering
WARNING: This page is about a different variant/trim than selected.
NOTE:
Carry out preliminary work as described in the document "Replacing drive belt". See 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N63)
, 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N55)
, 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (S63 T 0)
or 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N63O1)
.
Slacken screws (1)
Relieve tension on drive belt and remove from belt pulley (2). See 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N63) , 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (N55) or 11 28 010 REPLACING DRIVE BELT FOR ALTERNATOR (S63 T 0) .
Unscrew bolts (1) and remove belt pulley (2).
Installation note:
Lettering on belt pulley (2) must point forwards.
Replace microencapsulated screws.
Tightening torque 32 41 4AZ .