32 00 155 Kinematics Diagnosis System wheel alignment with ride height measurement without loading the vehicle: Notes

WARNING: This page is about a different variant/trim than selected.

General information

Prerequisite

Only BMW approved wheel and tire combinations are installed on the vehicle. The tread depth on the left and right differs by a maximum of 2 millimeters.

Safety instructions

TECHNICAL INFORMATION

Only carry out wheel alignment using a Kinematics Diagnosis System with ride height measurement and without vehicle load if the technical prerequisites have been complied with.
If the technical prerequisites are not complied with or this process concerns a damaged vehicle, carry out wheel alignment using a Kinematics Diagnosis System with vehicle load up to design position.
For more information see: 32 00 150 CARRY OUT KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH VEHICLE LOAD UP TO DESIGN POSITION .

Preprocesses