31 12 003 Removing and installing/replacing top right wishbone (M6)
WARNING: This page is about a different variant/trim than selected.
NOTE:
The wishbones are marked with R and L (2) and 2, 3 or 4 bore holes (1):
R or L (2) - Right or left wishbone
• •(1) - Wishbone under dimension variant
• • •(1) - Wishbone normal position (standard part - see Fig 1)
• • • •(1) - Wishbone over dimension variant
These camber correction arms are used to correct the camber values by 20 minutes. To be used only if the tolerance values are exceeded or undershot!
Necessary preliminary work:
- Remove FRONT WHEEL .
- Remove right-hand INTAKE SILENCER HOUSING .
IMPORTANT:
The screw connection for the spring strut/wishbone on the bottom will not be released!
Further procedure is identical to:
- Removing and installing/replacing TOP LEFT CONTROL ARM .