13 54 020 Removing and installing/sealing right throttle valve assembly (N63)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: Picture shows the left throttle valve assembly, the procedure for the right side is identical.

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle valve assembly (3).

Installation:

Check plug connection (1) for coolant remnants. If necessary, clean plug connection (1) with compressed air.

Fig 1: Identifying Throttle Valve Assembly, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Throttle Body Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check stored fault message.

clear fault memory.