13 62 594 Removing and installing/replacing pressure sensor on right intake plenum (S63)

Necessary preliminary tasks: 

• Read out DME fault memory.
• Switch off ignition.
• Remove the engine with front axle. See REMOVING FRONT AXLE WITH ENGINE/TRANSMISSION (WITH DUAL-CLUTCH TRANSMISSION) or REMOVING FRONT AXLE WITH ENGINE/TRANSMISSION (MANUAL GEARBOX) .

Release wiring harness (1) from clamps.

Disconnect plug connection (2).

Release screws (3).

Tightening torque: 13 62 2AZ

Remove pressure sensor (4).

Installation note: 

Replace O-ring.

Fig 1: Identifying Pressure Sensor, Wiring Harness, Plug Connection, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Delete fault memory.