13 62 594 Removing and installing/replacing pressure sensor on right intake plenum (N63)

Necessary preliminary work: 

• Read out DME fault memory.
• Switch off ignition.
• Remove ELECTRONICS BOX .
• Draw off A/C SYSTEM .
• Secure engine in INSTALLATION POSITION .

Release screw (1).

Tightening torque 64 53 3AZ .

Detach A/C line (2) and place to one side.

Replace sealing ring on A/C line.

Fig 1: Identifying A/C Line And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screws (2) with a reversible ratchet, extension, universal joint and a magnetic Torx socket.

Tightening torque 13 62 2AZ .

Pull pressure sensor (3) out of left intake plenum.

Installation note: 

Coat sealing ring with lubricant.

Fig 2: Identifying Pressure Sensor, Screws And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Delete fault memory.