13 62 592 Removing and installing/replacing pressure sensor on right charge-air cooler (S63)

Necessary preliminary tasks: 

• Read out the fault memory of the DME control unit.
• Switch off ignition
• Remove right-hand INTAKE SILENCER HOUSING 

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 7AZ .

Pull pressure sensor (3) out of right intercooler.

Installation note: 

Replace sealing ring on pressure sensor.

Fig 1: Identifying Pressure Sensor, Screws And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Delete fault memory.